Miele Novatronic W828 - Where To Get An EL200D...

Main Page | Report this Page

Science Forum Index » Electronics - Repair Forum » Miele Novatronic W828 - Where To Get An EL200D...

Page 1 of 1

Author

Message

Harry Kiri...

Posted: Sat Jun 21, 2008 1:03 pm

Guest

Our Miele W828 has failed (displays a flashing rinse light). It pumps
water in, then tries to wash - but drum motor doesn't run. Blows
micro cct board fuse then displays flashing rinse light. Minute or so
later it then pumps the water out and operations cease.

Has anyone succeeded in getting a schematic out of Miele, or
alternatively know of a source of this, or a service manual? The
faulty board appears to be an EL200 D, which is priced at circa $600.

TIA for responses :-)

HarryK

Mike S...

Posted: Tue Jun 24, 2008 4:49 pm

Guest

"Harry Kiri" <no_spam at (no spam) no_spam.com> wrote in message
news:g3jfof01ba2 at (no spam) news2.nntpjunkie.com...

Quote:

appliance parts.
I would recommend you check all parts that connect to the board first for
shorts, especially that drum motor, to avoid damaging a new $600 circuit
board. If any other part is found to be shorted you should make sure it was
not caused by a water leak into the part.
Or find a local electronic repair shop that can diagnose and repair the
board to the component level. That should cost far less than replacing the
board. Most appliance repair shops will just replace the board, but an
electronic repair shop would likely be able to repair the board.

Page 1 of 1 All times are GMT - 5 Hours The time now is Sun Nov 23, 2008 1:47 pm Science Forum Index