Main Page | Report this Page
 
   
Science Forum Index  »  Electronics - Repair Forum  »  Thorens TD 180 Stuck on 78 speed...
Page 1 of 1    
Author Message
...
Posted: Sat Jul 05, 2008 9:40 am
Guest
I resently got my turntabl out of storage from a move and tested it
out all 3 speeds are stuck on 78 what needs fixing or is a new part
that is needed?
Sjouke Burry...
Posted: Sat Jul 05, 2008 2:56 pm
Guest
robertjdavi at (no spam) yahoo.com wrote:
Quote:
I resently got my turntabl out of storage from a move and tested it
out all 3 speeds are stuck on 78 what needs fixing or is a new part
that is needed?
In my case it was a sliding copper bush, where the

lubrication had become stuck.
So my first try would be to open it up, clean and lubricate
the moving/running parts, then check out (limit)switches
for corrosion.
Also check rubber bands for aging.
Eeyore...
Posted: Sat Jul 05, 2008 3:11 pm
Guest
robertjdavi at (no spam) yahoo.com wrote:

Quote:
I resently got my turntabl out of storage from a move and tested it
out all 3 speeds are stuck on 78 what needs fixing or is a new part
that is needed?

Don't know that model, but such speed selections are often by means of
stepped pulleys.

Inspect and look for something stuck (e.g. by hardened grease).

Graham
hr(bob) hofmann at (no spam) att.net...
Posted: Sat Jul 05, 2008 3:13 pm
Guest
On Jul 5, 3:11 pm, Eeyore <rabbitsfriendsandrelati... at (no spam) hotmail.com>
wrote:
Quote:
robertjd... at (no spam) yahoo.com wrote:
I resently got my turntabl out of storage from a move and tested it
out all 3 speeds are stuck on 78 what needs fixing or is a new part
that is needed?

Don't know that model, but such speed selections are often by means of
stepped pulleys.

Inspect and look for something stuck (e.g. by hardened grease).

Graham

You will have to remove the turntable to get at the stepped pulley.
That means taking the mounting plate off of the base, in most cases.

Bob Hofmann
 
Page 1 of 1       All times are GMT - 5 Hours
The time now is Tue Dec 02, 2008 2:44 am