"Fred" <frdrc@yahoo.com> wrote in message
news:raHBh.39660$eD2.556930@weber.videotron.net...
Hi everyone,
I didn't find a newsgroup for this particular subject so I decided to
post here.
Programming specs for 18F452:
http://ww1.microchip.com/downloads/en/DeviceDoc/39576b.pdf
I'm trying to understand the "code memory" programming of a 18F452 (or
same family PIC) using multi-panel writing (p. 10 and up). Microchip
explanation confuses me when it comes to the address I must use in the
TBLPTR register.
Is TBLPTR register actually holding the address of the code memory to be
program?
Using the equation in their programming flow (p. 13), it doesn't give a
linear incrementing address at each iteration of the programming loop:
Panel Base Address = (N-1) * 2000h
Addr = Panel Base Address + (8*LoopCount)
Anyone could shade some light?
Freddy
Your writing to a couple of 8 byte buffers, which are then all written
simutaniously to the code memory. addresses of these 8byte blocks of code
would be 2000h, 4000h 6000h etc.
You would apparently take you hex file and get the first 8 bytes of these
boundaries 2000h, 4000h, 6000h etc and write these values to the buffer.
Seems straight forward. ;)
Cheers
