| Science Forum Index » Electronics Forum » Altera Flex 10k probleem... |
|
Page 1 of 1 |
|
| Author |
Message |
| Marc... |
 Posted: Sat Jun 20, 2009 2:07 am |
|
|
|
Guest
|
Hi,
I have a problem with bringing out the INIT_DONE puls out of an Altera Flex
10k EPLD. I use Quartus II software on a PC.
I also use the EPC2 configuration device.
I enabled this bit in the design software and used a pull-up resistor of 1k
at the INIT_DONE -pin.
The signal stays low, always and it should go high when entering user mode.
Can anybody help me with that?
Marc |
|
|
| Back to top |
|
|
|
|
