| |
 |
|
|
Science Forum Index » Electronics Forum » Newbie question about breaking traces on perf board
Page 1 of 1
|
| Author |
Message |
| Bob Engelhardt |
 Posted: Sun Mar 30, 2008 2:58 pm |
|
|
|
Guest
|
I'm doing a little project on a perf board that has lines of traces (all
in one direction). I'll have local "runs" of 2-5, which will be
isolated by breaking the trace on each end. What is the best way to do
this: Exacto knife, Dremel, vibrating engraver, other?
Thanks,
Bob
BTW - I haven't actually tried any of these yet - maybe it's so easy
that this is a stupid question. If so, sorry, & I'm not trolling. |
|
|
| Back to top |
|
| no_one |
| Posted: Sun Mar 30, 2008 3:46 pm |
|
|
|
Guest
|
"Bob Engelhardt" <bobengelhardt@comcast.net> wrote in message
news:wcCdnXXZUY1bbXLanZ2dnUVZ_vGinZ2d@comcast.com...
Quote: I'm doing a little project on a perf board that has lines of traces (all
in one direction). I'll have local "runs" of 2-5, which will be isolated
by breaking the trace on each end. What is the best way to do this:
Exacto knife, Dremel, vibrating engraver, other?
Thanks,
Bob
BTW - I haven't actually tried any of these yet - maybe it's so easy that
this is a stupid question. If so, sorry, & I'm not trolling.
exacto usually does the job |
|
|
| Back to top |
|
| Bob Engelhardt |
| Posted: Mon Mar 31, 2008 2:28 pm |
|
|
|
Guest
|
no_one wrote:
Quote: exacto usually does the job
Thanks |
|
|
| Back to top |
|
| |
|
Page 1 of 1
All times are GMT - 5 Hours
The time now is Mon May 12, 2008 3:07 am
|
|
