| |
 |
|
|
Science Forum Index » Engineering - Joining (Welding) Forum » Airco Minarc 130 110vt welder
Page 1 of 1
|
| Author |
Message |
| Gunner |
 Posted: Sun Feb 11, 2007 6:18 pm |
|
|
|
Guest
|
Going back to the 110vt stick welder topic..I was installing some
powered chain hoists over the last few days on existing chainhoist
tracks and needed to weld up some cable supports and whatnot out of 2x
1/4" L steel. Was working ok with my Weldpack 100 until I ran out of
wire..(damn..thought there was more on the spool..sigh)...and as I was
working on a manlift 15' off the floor..a big machine (customer has
several) was out of the question. So he dug out an Airco "MiniArc 130",
110vt stick welder. With 3/32 6013..that little bastard was a Pleasure
to use. Must be inverter based as its quite light, but Airco has long
been out of business.
Anyone know who made this welder? Has an amps dial on the front, and an
off/on switch on the back..and thats all the controls it has. DC welder
Bout 5x6x20" long, black front, maybe red underpaint which leads me to
think Lincoln..but didnt think Airco had any rebadged Lincolns.
There is a picture of one here...
http://www.artmetal.com/enrique//wrought/architectural/railings/jessie/weld.JPG
Id LOVE to find one, or an equivelant.
And yes..it had more than enough oomph to turn a stick of 3/32 bright
red when I stuck the rod in the puddle a little too deep and was getting
very nice penetration in the 1/4" L and the 8" I-beam I was welding them
to. So a (good) 110vt stick welder will suit my purposes nicely.
Gunner
Political Correctness
A doctrine fostered by a delusional, illogical liberal minority and
rabidly promoted by an unscrupulous mainstream media,
which holds forth the proposition that it is entirely possible
to pick up a turd by the clean end. |
|
|
| Back to top |
|
| |
|
Page 1 of 1
All times are GMT - 5 Hours
The time now is Sat Oct 11, 2008 3:06 am
|
|