| Computers Forum Index » Computer Languages (Labview) » Reading data from hardware... |
|
Page 1 of 1 |
|
| Author |
Message |
| Marco Metzger... |
 Posted: Tue Apr 28, 2009 5:10 pm |
|
|
|
Guest
|
Hello,
this is the first time I use NI hardware. I have the USB-6009 unit which
runs well on NI-DAQmx (V4.5).
I'm trying to bring an input value to a Labview (V8.0.1). I know it sounds
stupid, but what must I do to measure a signal in Labview?
Best regards
Marco |
|
|
| Back to top |
|
|
|
| Freelance Embedded Systems Engineer... |
| Posted: Thu Apr 30, 2009 4:26 pm |
|
|
|
Guest
|
Marco Metzger wrote:
Quote: from other examples I saw that they have a palette DAQmx which is missing in
my installation. When I copy the symbols from other sample programs I can
use them, but why can I not see the DAQmx panel palette under Measurement
I/O?
Best regards Marco
What version of Labview are you using?
Do you have Measurement and Automation Explorer installed?
Do you see your device listed under NI-DAQmx Devices?
It sounds like you have an incomplete installation:
This newsgroup doesn't have a good following.
forums.ni.com is a better option.
http://forums.ni.com/ni/board/message?board.id=170&thread.id=400818 |
|
|
| Back to top |
|
|
|
|
